Problem with Power Windows...
 

Okay so heres the problem...
I installed a power windows kit about 3 months ago...no problems has occured until today...
-->I have blown two fuses today...

Also i installed a DIY grounding kit about 3 weeks ago...
-->Is this a possible cause??

Can anyone please tell me what to look for??
thanks

shit...make that 3 fuses...

When does the fuse popping occur?

good question...
On the second fuse--> the fuse blew when i pushed on the switch
Third Fuse--> It popped when i put on the car...

and the first?

the problem is probably a short created when you hit the switch. Check ALL wire connections at ALL points. Make usre nothing is touching, if you can, trace every wire and make sure nothing is pinched and causing a short somewhere.

the first must have been this morning...
either when i put on the car or when i touched the switch...i cant remember...

Does it do it when you try to roll down the passenger side window as well?

yea....that was on the second fuse...it blew when i put down the passenger side down

What abotu the driver side?

it was fine, until the third fuse--> which blew rite when i started the car..
could it be the power source?? im tapping the white/red wire...

What fuse is blowing? You didn't add a new fuse when you installed the kit?

Did you have to manually run any wires through your doors?

Does it blow fuses for BOTH the passenger side and drivers side?

theres only one fuse in the kit...its connected to the power source...
and yes i did have to manually run wires through the door jamb...
RITE now it blows when i put on the car...i'm running out of fuses

Open the doors and try again

Is the fuse after the tap (on the aftermarket wiring), or before (touching stock wiring)

the fuse is before the stock wiring...

Add me on MSN, rollz2low_420@hotmail.com