|
frayed 02 wires = no start? error codes inside p1300 Random Misfire p0136 ??????? p0302 #2 cylinder misfire (source civic service manual) p0301 #1 cylinder misfire (source civic service manual) p1399 ????? Wait To Start Lamp Circuit? Issues just came up this afternoon, and it wont fire. It started and right away i could feel it misfiring and shut it down immediately. I drove it around yesterday with no issues, no recent maintenance. I rented a diagnostic tool and these are codes given. no picture(yet) but one of the wires coming off the lower o2 sensor looks like it touched something hot at some point or shorted against another wire and melted through the insulation. how likely is it that this is the only culprit? What else would you start with? It wont run, so my options are limited to check what other conditions i have problems. 97 civic lx 112,000 miles new plugs (ngk v power) 500 miles ago |
Re: frayed 02 wires = no start? error codes inside its ur EGR valve. |
Re: frayed 02 wires = no start? error codes inside
Originally Posted by sl33pyriceboi
(Post 4473753)
its ur EGR valve. I'm starting to lean towards distributer-no spark |
Re: frayed 02 wires = no start? error codes inside really? haha mine had simular codes thrown n it was teh egr. well i hope someone gets u an answer. |
Re: frayed 02 wires = no start? error codes inside P0136 - Oxygen O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2)
Originally Posted by OBD-codes.com Symptoms There may be no visible symptoms to the driver. Poor fuel mileage, possible misfire, depending on O2 sensor position when sticking. Causes A code P0136 may mean that one or more of the following has happened: Faulty O2 sensor leak in exhaust close to O2 sensor Short to voltage on O2 signal circuit Open in circuit resistance caused by corrosion in connector Possible Solutions Replace the second oxygen sensor on bank 1 Repair open or short in signal circuit Clean corrosion from connector I'd say fix the wires or replace the sensor then reset the codes. |
Re: frayed 02 wires = no start? error codes inside solved- new distributor and new wires |
| All times are GMT -5. The time now is 03:02 AM. |
© 2024 MH Sub I, LLC dba Internet Brands