Rep Power: 0

Has anybody done this? if so, where did you find the mesh to cut it out of? I want to do this but can't find any aluminum mesh for it. Home Depot has the gutter guard, but it's too short...

OOOrrr.... if anyone has it for sale, how much?

 
Rep Power: 0

Cue2K1, Andoy and i think Kwinter all got it done before

PM Cue for more info

 
Rep Power: 0

u buy the meshing at Canadian Tire
it's like 50 dollars

 
Rep Power: 0

then i might as well by the folio tec mesh for 50 dollars right????

 
Rep Power: 0

Thanks for the replies... iamfob, quick as always..

yea, I just saw the Canadian Tire flyer and they apparently have some kind of mesh there now... I'm gonna check it out

 
Rep Power: 0

I am selling my grillcraft lower grill painted gun metal for $110... It fits nice and snug and will look better in the end then one from Canadian tire...

 
Rep Power: 350

getting a new front bumper REDVIC???

 
Rep Power: 0

no....go to home depot and get the mesh...it's much cheaper than brappy tire

make sure u buy a lot from home depot cuz if u f u c k up then u can use a new piece and try again

Cue2K1 done 2 or 3 sets already and he is the master of DIY chicken wirre mesh grill
hehhehehhehe

 
Rep Power: 0

the mesh at home depot isn't long enough... I've checked a few home depot's and all they have is gutter guard thats 3 feet long... need at least 4 feet i think... and couldn't find anything in rolls...

REDVIC.. thanks, but i'll pass...

I got the mesh from canadian tire.. 50 bucks

 
Rep Power: 0

I think he's planning on covering the whole thing to give it the "grillcraft" look. Good luck dood!!! When I did the bottom grill I only covered the middle part of the grill...