D16y8 - NEW ROCKER ASSEMBLY not sitting flush on Previous head?
Thread Starter
Registered!!
Joined: Oct 2024
Posts: 1
Likes: 0
Rep Power: 0 
D16y8 - NEW ROCKER ASSEMBLY not sitting flush on Previous head?
Hey guys, I am new to the HONDA scene, recently I discovered my old camshaft in my engine was scored significantly and was not allowing my car to run.
I picked up a different d16y8 head, and am attempting to swap the camshaft and rockers into my car, however,
As I put the new camshaft and in my car, the rocker assembly does not seem to be sitting flush to the point where I can tighten it snug. There is too much of a gap and does not seem to go into the holes flushly.
If there is anything that I am missing, feel free to help me out, I would appreciate it greatly.
I picked up a different d16y8 head, and am attempting to swap the camshaft and rockers into my car, however,
As I put the new camshaft and in my car, the rocker assembly does not seem to be sitting flush to the point where I can tighten it snug. There is too much of a gap and does not seem to go into the holes flushly.
If there is anything that I am missing, feel free to help me out, I would appreciate it greatly.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
Kio
Engine Performance Modifications
1
Jul 19, 2020 12:12 AM
PAINT FREAK
Mechanical Problems/Vehicle Issues and Fix-it Forum
0
Mar 1, 2009 01:11 AM
ekhatch96
General Honda Civic Forum Archive.
0
Apr 11, 2008 10:19 PM
