Rep Power: 294

well i was contemplating on this, since the prb mani barely fits in our engine bays(has llike 1/2" clearence from the rad support) would the rbc fit in our engine bays?

 
Rep Power: 254

my buddy has the RBC intake mani on his 7th gen coupe (k-swap). it fits but its pretty much rubbing against the rad support. he stuck a cut rubber hose between the rad support and the IM, it works fine. he had to trim the rad support a little but IT DOES fit. just be patient with it because it does fit.

 
Rep Power: 292

^ Yup, he's right... It'll hit the rad support unless you trim the support a bit. No big deal if you arent scared to cut into it a bit.

 
Rep Power: 297

https://www.civicforums.com/forums/7...24-2007-a.html

 
Rep Power: 403

i don't wanna cut mine, i would have done the rbc a while ago but im fine with my prc