RBC mani on swapped EM/ES
Registered!!
iTrader: (20)
Joined: Sep 2002
Posts: 4,111
Likes: 1
From: Cleveland, OH
Rep Power: 329 
i think you'll have to make a couple cuts and bend back the rad. support, at the least. would probably make a CAI more difficult to fit too, RSX CAI anyways, since i had issues before with it hitting the transmission, and the RBC points the CAI towards it even more.
Joined: Jun 2002
Posts: 3,242
Likes: 0
From: so cal djmota=oscar
Rep Power: 323 I was prepared to butch my support in the future. now hearing that it will only need a little trim and bend makes me happy 
well i make custom cold air intakes so i aint too worried about CAI.... but when we test fitted the RBC on my car all i did was take a little dremel and about 15 minutes worth of grinding it fit... not a big deal IMO
Thread Starter
Registered!!
iTrader: (11)
Joined: Sep 2002
Posts: 600
Likes: 0
From: Da O.C. / IRAQ
Rep Power: 0
Originally Posted by xproductionz
well i make custom cold air intakes so i aint too worried about CAI.... but when we test fitted the RBC on my car all i did was take a little dremel and about 15 minutes worth of grinding it fit... not a big deal IMO
hmmm...interesting....lemme know how it works out. wouldn't all that grinding hurt the integrity of the manifold in the long run?
Originally Posted by CdKoInU
hmmm...interesting....lemme know how it works out. wouldn't all that grinding hurt the integrity of the manifold in the long run?
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
redcloud
I.C.E. (Audio) & Electrical Upgrades
25
Aug 12, 2015 01:23 PM
