someone help me out
Thread Starter
Registered!!
iTrader: (2)
Joined: Jul 2004
Posts: 1,083
Likes: 0
From: Saginaw, MI
Rep Power: 278 
someone help me out
Well, I took off my needles because I was working on a project to make my gauges brighter. Anyways, I took off the needles, but now the calibration is kinda off, but not by much. I just filled the gas tank, so thats good. I just took it out for a 15min drive, so the engine is at normal operating temp, but ill wait until later tonight when it goes down.
I was reading a DIY and a fix to calibrate the needles, and it said to turn the key into the ON position, and then connect the needles from there. I tried that like 3x and the needles are slightly higher than they should be. I know I dont idle at 1000rpm. Any suggestions on what I should do??
I was reading a DIY and a fix to calibrate the needles, and it said to turn the key into the ON position, and then connect the needles from there. I tried that like 3x and the needles are slightly higher than they should be. I know I dont idle at 1000rpm. Any suggestions on what I should do??
