Rep Power: 448

im trying to put something together for the next meet but i need some imput from you guys

how does June 5th (Sunday) sound?

 
Rep Power: 0

I've got to work on Sunday so I'd be out. Saturday the 4th?

 
Rep Power: 0

Im a no show for the 5th!

Peace

 
Rep Power: 283

4th or 5th works for me. The following weekend is no good for me though.

 
Rep Power: 290

possible, why a sunday?

 
Rep Power: 448

because most people dont have to work on Sundays

 
Rep Power: 0

i'm down for the weekend

 
Rep Power: 448

im thinking about doing a run up south mountain

 
Rep Power: 283

Did you go a couple of weeks ago, How was it?

 
Rep Power: 0

Either day I have to work...so lets get a date nailed down so I can get the day requested off. Im down to go though.

 
Rep Power: 0

Maybe, hopefully I dont have kids and can get away.

BTW, does anybody know how to install a clutch, clutch master/slave cylinder, and tranny mount?? My tranny is off by about a half inch to an inch, my mount is ripped in about 4 spots, missing rubber, rubbers hanging out like an inch where it shouldnt be. This sucks, and I dont want to pay labor (more of tipping my friend a lot of money at Midas). Let me know if anybodys down next weekend maybe.

Peace

 
Rep Power: 0

hmm, i'm not sure what is going on that weekend or not, but i'll probably be down yes - i dont work weekends

 
Rep Power: 448

no...there wasnt much interest from anyone here

 
Rep Power: 0

ill probably go, but dont know if my cars gonna be able to go yet. it may not be fixed by than. with birthdays for the kids and all my other finances, its gonna take me a while to drive the civic again. this sucks

 
Rep Power: 0

im probably down for that weekend im sure i have nothing planned

 
Rep Power: 263

Damn I wanna come up for another meet, but I'll be in Maryland that weekend for my brothers graduation!!

 
Rep Power: 0

i'll be there if it's on sunday or late sat. afternoon

 
Rep Power: 337

im out.

 
Rep Power: 379

I can help with the clutch

 
Rep Power: 0

nice, you know how to do a master or slave cylinder as well?? I need to get a new tranny mount, but the busted one will be taken off anyways when the clutch gets installed. Im gonna try to get my motor mount bushing installed before all of this as well. Thanks a lot, Ill let ya know.

Peace

 
Rep Power: 379

Nah but I can figure anything out. I know the clutch because we just switched mine over when I put the new engine in a few weeks ago

 
Rep Power: 0

right on, the clutch should be the hardest part. It will be a couple weeks til I have everything, and the master cylinder may not even need to be installed if it works after I replace the other crap. The slave will need to be replaced while the tranny is apart. Ill let ya know when Im gonna be doin all this. Thanks

Peace