Rep Power: 0

I just installed my new Greddy Sp2 system on y 2001 dx coupe. It fits perfect and the sound is ok....but the pipeing hangs pritty low to the ground. There is maybe five inches of clearence, and today i scraped the bottom pulling into a parking lot which i have driven into tons of times with no problems before i installed the exhaust. I was just wondering if anyone else has had problems with clearence. I always fck new parts up on my car

 
Rep Power: 0

You shouldn't be that upset... ("I always fck new parts on my car.")

Seriously my RSR ExMag sits lower and probably is somewhere around 6 inches. Did you hit on the tail or the pipe itself behind the cat?

 
Rep Power: 381

I do it with a stock muffler

 
Rep Power: 0

my exhaust scrapes, my car is dropped 3-1/2"... on 19s, with 2.5" piping with some areas 3" (custom special stuff for backpressure and flow, we do it out here, more power on dyno, weird, and hard to find right spots, but money after that)... but i hit it all the time, its 3-1/4" off the ground in most spots, 2-3/4" at one spot.... shisty... but i just get it redone if it wears a hole... hasnt happened yet though, not that i drive it a lot... WANNA BUY MY CAR ANYONE????

 
Rep Power: 0

Drive over speed bumps and driveways at an angle...

 
Rep Power: 0

I drove at an angle but the pipeing between the cat and the muffler is one big **** mark. Its not that bad but im pissed cause its new.