Rep Power: 0

Hey everyone, install time for my new kit is coming up soon. and I was just wondering, those of you that have installed the Xenon side skirts yourself, are there any gas lines or anything like that which could possibly be punctured when you mount the brackets under the car?

 
Rep Power: 344

shouldn't be... i did it and i've had no problems so far. that was for the wingswest tho. maybe i should check up on that

 
Rep Power: 0

nope i have them and theyre fine nothing to worry about

 
Rep Power: 0

The only thing you have to worry about is snow building up under them if you live where there is snow. I have to dig mine out every week.

 
Rep Power: 381

^ aww ****. I didnt even think about that. Mine should be done in the paintshop this week.

 
Rep Power: 0

It should be ok, winter is over in a month.

 
Rep Power: 0

did you guys need a jack when you installed them?

 
Rep Power: 315

i used some waterproof adhesive and they are stuck on there quite well and they dont budge

 
Rep Power: 0

brackettes on them are pimp.. and tape.... no gas lines tho. nothing runs in the frame look under car and u can see gas line

 
Rep Power: 0

so what exactly is the greyish/spackle stuff that i will be drilling into?

 
Rep Power: 0

no clue but i dount itll do anything haha

 
Rep Power: 315

i think its just protecting your underbody of the car. watch your brake lines, lol.

 
Rep Power: 0

what everyone said so far is correct, I put on the Xenon and drilled into the rubber undercoating, I didn't drill into anything, but not sure if anything it there. and yes you have to jack the side of the car you are working on for sure. Good luck man