AEM cai idle drop...
Thread Starter
Registered!!
Joined: Apr 2002
Posts: 5
Likes: 0
From: Millbrae, California, US
Rep Power: 0 
AEM cai idle drop...
helo well i have AEM CAI with bypass valve and my problem is when i rev all the way to redline in 1st n pop it bak to N.. the needle would drop n just hit the stopper.... n stall so i dont wat the problem is..... i even mess with the throttle cable to make it rev higher but that still didn't hlp.. now is at 750-1k (sometimes only) but yea.... can someone give me a hand on this.... b/c is gettin annoyin after u race n it stalls on my ***
I need TP for my bunghole
iTrader: (3)
Joined: Jan 2003
Posts: 7,103
Likes: 0
From: OXNARD, CA. SoCal. "805", North of L.A.
Rep Power: 358 
Make sure the air sensor is in place.
Then disconnect the battery.
Wait about a minute and then connect it back up.
This will reset the cars computer.
That might help.
Then disconnect the battery.
Wait about a minute and then connect it back up.
This will reset the cars computer.
That might help.
I need TP for my bunghole
iTrader: (3)
Joined: Jan 2003
Posts: 7,103
Likes: 0
From: OXNARD, CA. SoCal. "805", North of L.A.
Rep Power: 358 Here is the link to the TSB issue causeuing the engine t stall out
http://www.7thgencivic.com/forums/sh...hreadid=108733
Also here is the service bulltin for the issue:
http://www.7thgencivic.com/forums/sh...hreadid=108733
Also here is the service bulltin for the issue:
Last edited by PunkingCivic; Apr 14, 2006 at 08:24 PM.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
junkyardguy
Mechanical Problems/Vehicle Issues and Fix-it Forum
20
Sep 6, 2015 10:07 PM
