AUGh I bent my floorboard! Help!
Thread Starter
Registered!!
Joined: Jun 2001
Posts: 457
Likes: 0
From: Fresno, California, US
Rep Power: 0 
AUGh I bent my floorboard! Help!
A monkey-assed friend of mine was jacking up my car as we were mounting my side skirts, and the floorboard bent. Right along the line where the side floor panels run (the one connected to the gas door/trunk latch) the floor is bent upwards a bit. What should I do? The only advice I've heard is put a piece of wood down over it and start pounding with a sledge. I suppose thats all I have the capability to do? Any help is appreciated
Registered!!
Joined: Apr 2001
Posts: 379
Likes: 0
From: EL Paso, Texas, US
Rep Power: 0 I did the exact same thing only I'm such a dumb-@$$ that when I saw the car coming down on the jack, I thought that my jack was lowering on it's own, so I jacked it up higher, THEN I realized that it was my car the was lowering.
Anyway, I got the same advice as you from everyone I asked - put a 2 X 4 down over it and aim carefully with a sledge hammer.
Anyway, I got the same advice as you from everyone I asked - put a 2 X 4 down over it and aim carefully with a sledge hammer.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
OptimisticWay
7th Generation Civic 2001 - 2005
4
Sep 18, 2015 09:37 PM
MichaelLW
Fuel, Oil, Cleaners & Other Maintenance
2
Sep 14, 2015 07:15 AM
