DIY: K20/K24 into 2001+ Civic **Updated 4/20/2008**
10-29-2007
#151
I just burnt my tongue
iTrader: (8)
Join Date: Mar 2004
Location: Chino Hills, CA
Age: 37
Posts: 4,990
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 295 
Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
im doing a k20 swap right now in a special lil 4 door...hehe...i might post pix when its done but i dunno cuz people these days and stealing cars is getting very bad
11-17-2007
#152
Registered!!
Join Date: Aug 2007
Location: Las Vegas
Age: 40
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 
Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
Its like if X doesnt event care anymore. He doesnt respond or anything. I took on this swap just because of his swap guide. Now im stuck, and dont even have any help from X...
11-17-2007
#154
Thread Starter
iTrader: (14)
Join Date: Jul 2004
Location: Las Vegas, NV
Posts: 3,120
Likes: 0
Received 1 Like
on
1 Post
Rep Power: 273 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
apparently if you are asking someone for help it must not be me because i havnet got any messages from you
11-17-2007
#155
Registered!!
Join Date: Aug 2007
Location: Las Vegas
Age: 40
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
lol, Didnt mean too sound ****ed up. I was drunk, and a little down last night... lol. No i havent pm him. I figured id just write my questions here and he would respond, guess not @@ lol Ya X, i meant "even."
Anyways, Is there any diffrence between an air/fuel ratio sensor, and a oxygen sensor? Are they the same thing? Would the 2 oxygen sensors on my d17a2 work for my k20a2 swap?
I went to the salvage yard where i bought my engine, and asked them if i can have the oxygen sensor, and air/fuel ratio sensor from the k20 i purchased. They said, "why cant you use the ones off your d17?" "All of hondas oxygen sensors are the same and universal. I told them the colors are diffrent. They said "it doesnt matter, just find out which is the ground, heater, etc." We argued for a while but I didnt know what else to tell them other then, "because the guy on the internet said so" lol
They told me if i can find out whats the diffrence between them, and why they arent compatble, they would help me out. So im just very confused right now
Plz help!
Anyways, Is there any diffrence between an air/fuel ratio sensor, and a oxygen sensor? Are they the same thing? Would the 2 oxygen sensors on my d17a2 work for my k20a2 swap?
I went to the salvage yard where i bought my engine, and asked them if i can have the oxygen sensor, and air/fuel ratio sensor from the k20 i purchased. They said, "why cant you use the ones off your d17?" "All of hondas oxygen sensors are the same and universal. I told them the colors are diffrent. They said "it doesnt matter, just find out which is the ground, heater, etc." We argued for a while but I didnt know what else to tell them other then, "because the guy on the internet said so" lol
They told me if i can find out whats the diffrence between them, and why they arent compatble, they would help me out. So im just very confused right now
Plz help! Last edited by NastyNunez; 11-17-2007 at 10:58 PM.
11-19-2007
#157
Registered!!
iTrader: (6)
Join Date: Apr 2006
Location: long island
Age: 37
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 
Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
Yo x I got a lil problem, I just finsihed my swap k20a2/k24a1 when I whent to start it, it sat at idel for 2 sec then raised to 2000 rpm then dropped down and shut off, so I thouht maybe its the inmobilizer changed it nope, I thought maybe it was the map tryed like 10 differnt map, nope wasn't that, I got all my sensors connected, my fluids levels good, I cant see what is wrong or what it can be, my mods are aem v2 cold air intake, apexi n1 cat back, after market headers and downpipe that's it, any ideas what it can be guys....... '''
'''
11-19-2007
#158
Registered!!
Join Date: Aug 2007
Location: Las Vegas
Age: 40
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
I just noticed where you got your car dyno'd at X. LDL shop...lol. You cool with the people there? I had them order my hasport mounts for me. That asian lady seemed pretty cool in a wierd way... She told me they dyno/kpro etc. How much they charge you for the dyno run?
Last edited by NastyNunez; 11-19-2007 at 01:04 PM.
11-20-2007
#160
Registered!!
iTrader: (2)
Join Date: Mar 2006
Location: Orlando, FL
Age: 37
Posts: 207
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
the best way to talk to someone is clicking on their username, scrolling down to "send a private message to xproductionz", and start typing....
11-20-2007
#161
Thread Starter
iTrader: (14)
Join Date: Jul 2004
Location: Las Vegas, NV
Posts: 3,120
Likes: 0
Received 1 Like
on
1 Post
Rep Power: 273 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
haha.. u guys gotta remember im not on here 24 hours a day 7 days a week...
streethrow - check your iac.. the one under the thorrlte body.. take off the screws and clean inside of it and try it again... is there any CEL
nasty - LDL.. lol.. yes there good friends of mine.. dennis and marisa.. the filipino... what they charge me and what they charge customers are 2 different prices... if you ever go to acme2 then you have met me
as for the o2... i think the junk yard you go to is idiots... not all o2 sensors are the same.. you need the o2 sensor from the rsx cause its a wideband sensor... the sensor for our civics are narrow band.. your jus gona throw a check engine likght.. i think its stupid as they argue with you over a sensor... why cant they jus give it to you?? or sell it to you?? why they giving such a hard time.. obviously they knew the sensors were different cuase they were hesitant to give it to you
streethrow - check your iac.. the one under the thorrlte body.. take off the screws and clean inside of it and try it again... is there any CEL
nasty - LDL.. lol.. yes there good friends of mine.. dennis and marisa.. the filipino... what they charge me and what they charge customers are 2 different prices... if you ever go to acme2 then you have met me
as for the o2... i think the junk yard you go to is idiots... not all o2 sensors are the same.. you need the o2 sensor from the rsx cause its a wideband sensor... the sensor for our civics are narrow band.. your jus gona throw a check engine likght.. i think its stupid as they argue with you over a sensor... why cant they jus give it to you?? or sell it to you?? why they giving such a hard time.. obviously they knew the sensors were different cuase they were hesitant to give it to you
11-20-2007
#162
Registered!!
iTrader: (6)
Join Date: Apr 2006
Location: long island
Age: 37
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
nope no cel thats the thing, someone had a simlar problem on k20a and they said it was their map sensor and it also didnt display a cel, or it can be a vacuum leak am guessing
11-21-2007
#163
Registered!!
Join Date: Aug 2007
Location: Las Vegas
Age: 40
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
Ok cool, thanks X. The salvage yard i go to is called "all japanese" Off of lamb by the 215. Ima go back down there and talk to them again. One last thing...lol. So is there any diffrence between an air fual ratio sensor, and an 02 sensor?
11-22-2007
#164
Thread Starter
iTrader: (14)
Join Date: Jul 2004
Location: Las Vegas, NV
Posts: 3,120
Likes: 0
Received 1 Like
on
1 Post
Rep Power: 273 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
go to all japanese and talk to brent.. tell him mike from acme2 sent you.. he knows who i am.. he even has my number
11-22-2007
#165
Thread Starter
iTrader: (14)
Join Date: Jul 2004
Location: Las Vegas, NV
Posts: 3,120
Likes: 0
Received 1 Like
on
1 Post
Rep Power: 273 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
grab a couple cans of brake cleaner... start the car after its warm... spray brake cleaner around the manifold where the mani and head meet... around the gasket area... spray under the manifold where the plate with the 4 bolts are... spray around the throttle body area.. what you are looking for is for the motor to bog or drop idle while doing this... if you spray a particular area and itsucks up the brake cleaner... that means u got a vacumm leak in that area
11-23-2007
#166
Registered!!
iTrader: (6)
Join Date: Apr 2006
Location: long island
Age: 37
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 4/29/2007**
grab a couple cans of brake cleaner... start the car after its warm... spray brake cleaner around the manifold where the mani and head meet... around the gasket area... spray under the manifold where the plate with the 4 bolts are... spray around the throttle body area.. what you are looking for is for the motor to bog or drop idle while doing this... if you spray a particular area and itsucks up the brake cleaner... that means u got a vacumm leak in that area
i fixed it it was the sensor under the TB,i think its called the rotary air control vavle, not sure if its the IAC but yea cuase when i unpluged it,the car stayed on like a champ, yo on DIY relay i have a differnt relay so i was woundering with numbers are 30, 87a, 87, 86, and 85????
12-10-2007
#170
Registered!!
Join Date: Jan 2006
Age: 44
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 11/24/2007**
Sup guys I just got a K20a3 and I was wondering what intermediate shaft do I use well I also need a part number so I can buy it...cuz I couldnt find it on:
http://www.hondaautomotiveparts.com/...A5MT&catcgry5=
Also do I just need the engine harness for the si or what other harness do I need...thanks....
http://www.hondaautomotiveparts.com/...A5MT&catcgry5=
Also do I just need the engine harness for the si or what other harness do I need...thanks....
12-16-2007
#174
Registered!!
iTrader: (1)
Join Date: May 2006
Age: 42
Posts: 713
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 226 Re: DIY: K20/K24 into 2001+ Civic **Updated 11/24/2007**
Sup guys I just got a K20a3 and I was wondering what intermediate shaft do I use well I also need a part number so I can buy it...cuz I couldnt find it on:
http://www.hondaautomotiveparts.com/...A5MT&catcgry5=
Also do I just need the engine harness for the si or what other harness do I need...thanks....
http://www.hondaautomotiveparts.com/...A5MT&catcgry5=
Also do I just need the engine harness for the si or what other harness do I need...thanks....
12-17-2007
#177
Registered!!
Join Date: Dec 2007
Age: 44
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: DIY: K20/K24 into 2001+ Civic **Updated 11/24/2007**
sorry its a 04 vp no tack can i switch the cluster? and I found a K20Z1 for$3000 Is that something I sould look into?
12-17-2007
#178
Registered!!
iTrader: (1)
Join Date: May 2006
Age: 42
Posts: 713
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 226 Re: DIY: K20/K24 into 2001+ Civic **Updated 11/24/2007**
The K20z1 is a more difficult swap than the a2, but it has been done. There are just more chanllenges with the wiring that with the a2. IMO I would stick with the a2, and 3k sounds pretty cheap I would be skeptical.
