DAMN! Nicest SOHC motor i've seen in awhile!
Thread Starter
I wish I was asian
iTrader: (1)
Joined: Nov 2002
Posts: 5,083
Likes: 0
From: chantilly, Virginia, US
Rep Power: 336 
DAMN! Nicest SOHC motor i've seen in awhile!
here is a mod list...should answer some of the questions.
1.5 block bored 20 over
20 over 9:1 D16 weisco pistons w/ rings
cunningham 1.5 rods
clevite77 bearings
reground 1.5 crank
stupid neformz block guard (gave up waiting on sleeves after 8 months)
unorthodox race crank pulley w/ tecII trigger wheel (for a later date)
unorthodox alt pulley
unorthodox adjustable cam gear
unorthodox aluminum flywheel w/ frictionplate (ballanced)
ACT extreme pressure plate with 6 puck clutch disk
STR intake manifold
climax fuel rail
RC 550cc injectors (for now, hopefully i'll need bigger!)
SX adjustable fuel pressure regulator
SX fuel filter
hondata intake manifold gasket
stock multi-layer steel headgasket
stock 1.5 throttlebody
Port Flow Design turbo worked cylinder head
Web dual valve springs and retainers
custom 321 stainless steel exhaust manifold
custom 304 3" downpipe
custom 304 dumptube
custom oil feed and oil return lines w/ electronic oil pressure gauge
tial 40mm wastegate
tial blow off valve
Inovative Turbo Systems t3/t04E turbo 50 trim w/ stage 5 exhaust
Precision 24x8x3 intercooler with custom end tanks and brackets
custom intercooler piping
Hondata S100 with boost option
3 bar map sensor
apexi AVCR boost controller
DX transmission
walbro in tank fuel pump
ARP head studs
and all new maitnance parts...water pump poil pump gaskets etc etc
and no. this isnt my engine.
Last edited by cambo; Jun 9, 2003 at 05:16 PM.
Thread Starter
I wish I was asian
iTrader: (1)
Joined: Nov 2002
Posts: 5,083
Likes: 0
From: chantilly, Virginia, US
Rep Power: 336 its not done yet (from what i'm told)
he's still waiting for the intercooler before he even starts it up. should be coming in within a few days.
he's still waiting for the intercooler before he even starts it up. should be coming in within a few days.
x1000 
Thread Starter
I wish I was asian
iTrader: (1)
Joined: Nov 2002
Posts: 5,083
Likes: 0
From: chantilly, Virginia, US
Rep Power: 336
dyno'd to 275-300 HP on LOW BOOST. the engine is still brand new. on the dyno, there was some spike in the boost and it cleared 300 whp on the first go because of the spike. since the engine is not broken in, it has been tuned to 14 PSI, producing 275ish whp and over 200 ft/lbs tq. 400 whp is quite possible on race gas and more boost. Compared to a 300whp B18, this easilly FEELS like a 400 horsepower motor...just due to the turbo size, the redline, manifold, the set up in general.
Reppin Stage 7
Registered!!
iTrader: (1)
Joined: Aug 2002
Posts: 3,009
Likes: 0
From: San Francisco, California, US
Rep Power: 0 damn, he must have some hard time tuning that thing....but it is nice, I was going to say he would probably pull about 300 HP with that setup, I was pretty close.
