Jun 19, 2005
  #1  
how long does everyone wait for their ride to warm up? the manual says about a minute. i wait at least 2. i mean from a cold crank.
Reply 0
Jun 19, 2005
  #2  
probably about a minute...I usually spend that time picking out a CD to listen to.
Reply 0
Jun 19, 2005
  #3  
Quote: probably about a minute...I usually spend that time picking out a CD to listen to.
Exact same thing I do. Kick ****.
Reply 0
Jun 19, 2005
  #4  
about 45 seconds i guess when it's cold outside. i drive slowly for like 3 or 4 minutes after that.
Reply 0
Jun 19, 2005
  #5  
yup about a minute. Just drive below 4k until it warms up.
Reply 0
Jun 19, 2005
  #6  
yeah i don't put it past 3k till the needle is right below the middle. its sluggish till it warms up and then the engine gets goin.
Reply 0
Jun 19, 2005
  #7  
i wait for the temperature needle to rise a couple of lines pass the redline. It takes about 3-5 minutes.
Reply 0
Jun 19, 2005
  #8  
I wait until it hits the first line, about 2 min.
Reply 0
Jun 20, 2005
  #9  
From cold, probably a little under a minute.
Reply 0
Jun 20, 2005
  #10  
I am letting out the clutch as i turn the key.
Reply 0
Jun 20, 2005
  #11  
I wait till the rpms drop to 750....I dont drive until then!
Reply 0
Jun 20, 2005
  #12  
however long it takes me to get out of the house after I've hit the remote start...so anywhere between 1-5 mins.
Reply 0
Jun 20, 2005
  #13  
Iv got remote start, so i usually start it when i start walking to my car from work, or in the morning 2-3 minutes before i go out to the car. I like to let it warm up because i always have to floor it to get out of my neighborhood or to get on the interstate from work.
Reply 0
Jun 20, 2005
  #14  
About a minute. I don't drive hard until the engine is up to normal temp. Then I put my foot in it.
Reply 0
Jun 20, 2005
  #15  
usually about 2 mins, in that time im checking out whats playin on the xm radio "axis of rock". theres been a few times i have been in a hurry and just turned it on and gone though. my clutch doesn't feel right until its warmed up though, am i the only one with that prob??
Reply 0
Jun 20, 2005
  #16  
Depends on how cold it is. If it's mid-winter and it's 10 degrees out, I let it run about 5 minutes or so then drive slowly (rpms not over 3000) until the engine is warmed up. If it's summer and it's 95 degrees out, I usually only wait about 10 seconds (about how long it takes me to put on my seatbelt and chose which SIRIUS Satellite radio station I want to listen to)
Reply 0
Jun 20, 2005
  #17  
I have no idea. I live in SC where it was 76 at midnight last night. not too worried about cold starts here. lol
Reply 0
Jun 20, 2005
  #18  
Even in the winter, no more than a minute or so. You will find your car will warm up faster if you actually start driving instead of sitting an idling (you also won't waste as much gas). Just drive easy (ie. keep the revs low) until its up to normal operating temp.
Reply 0
Jun 20, 2005
  #19  
i wait till the temp gauge reaches a little below the middle about 5 min a little less
Reply 0
Jun 20, 2005
  #20  
barely any time when its hot out, but i wait till the revs get to 1000 in the winter.
Reply 0
Jun 20, 2005
  #21  
I ususally just drive REALLY slow until the needle gets a lil under the middle....
Reply 0
Jun 20, 2005
  #22  
Quote: barely any time when its hot out, but i wait till the revs get to 1000 in the winter.
Same here..

Just out of curiosity, where does your rpm's hover at from a cold start in the winter there, pb? I think mine hovers in the vicinity of 1250rpm's on a cold start.. and I have my throttle-body cable self-adjusted.
Reply 0
Jun 20, 2005
  #23  
at least a minute
Reply 0
Jun 20, 2005
  #24  
I let it warm up until the needle is on top of the "C" then drive slowly until operating temp is reached.
Reply 0
Jun 20, 2005
  #25  
Quote: Same here..

Just out of curiosity, where does your rpm's hover at from a cold start in the winter there, pb? I think mine hovers in the vicinity of 1250rpm's on a cold start.. and I have my throttle-body cable self-adjusted.
depends on the morning. sometimes around 2k...sometimes a bit more. it gets fvcking cold here in the winter. plus i dont have a civic anymore, i have a 99 miata, so that might have a different normal cold start rev.

edit: nevermind...youre in friggin ontario, im sure it gets much colder there than it does here. LOL
Reply 0
Jun 21, 2005
  #26  
Even if it's hot out, the engine should still be warmed up. The point of warming up the engine is to get the oil into the moving parts inside the engine so that it will run smoothly. On a cold start, all the oil has been receded back into the oil pan. When the car warms up, the oil returns back to the moving parts to avoid wear and tear.
Reply 0
Jun 21, 2005
  #27  
i was told it was because your engine is made of multiple types of metal so different parts expand at different speeds so if you stress it before everything has expanded you will f(*) your engine up.
Reply 0
Jun 21, 2005
  #28  
Quote: edit: nevermind...youre in friggin ontario, im sure it gets much colder there than it does here. LOL
LOL.. yeah, Mississauga's basically right beside Toronto (30min drive into downtown)

Apparently NY and NJ winters are somewhat comparable.. I've only ever been there during the summer.. driving through downtown NY with the heat on full blast aimed out the windows in an attempt to cool the engine and prevent it from overheating LOL
Reply 0
Jun 21, 2005
  #29  
I'm in Miami It's never cold down here, but does taht exclude me? cause I never wait even 30 secs.
Reply 0
Jun 21, 2005
  #30  
Quote: i was told it was because your engine is made of multiple types of metal so different parts expand at different speeds so if you stress it before everything has expanded you will f(*) your engine up.
very true, it happened with my buick. i stopped waiting a couple of minutes for the car to warm up and it messes up my valves. drove it too hard without letting it warm.
Reply 0