Rep Power: 0

i finally picked up my new audio stuff today. the only problem im running into is hooking up the subs to the amp. i bought 2 12" alumapro alchemy mx's and am running them a crossfire vr600d amp. im confused since theres 2 sets of "+ and -" on each sub, which i assume means dual voice coil. im lookin at the wiring diagram for the amp and im pretty confused and i dont wanna eff anything up. someone please help me to understand how to hook this up. and if it makes a difference which i assume it does, the amp is a mono block configuration.

 
Rep Power: 338

eaiset way to wire is to wire each individual woofer to itself, thats pos to neg , one on each coil.

that leaves one pos and one neg left on either side of teh woofer, you combine the positives of both amps and hook those to the + on the amp, then you double up the negatives, one from each woofer, and go to the negative side of the amp.

wired for 4 ohms. done.

 
Rep Power: 0

coil impedence, amp ohm load limits ? this makes all the difference

 
Rep Power: 0

Make sure they are dual 4 ohm coils before you wire it.