Different ignition coils on Si?? Summit Stinks!
Thread Starter
Registered!!
Joined: Aug 2017
Posts: 7
Likes: 0
Rep Power: 0 
Different ignition coils on Si?? Summit Stinks!
Ordered accel 140311-4 as per my fitment guide on summit racing (2003 civic si hatch 2.0)
And they turned out to be too big and with 3 prongs instead of my 2 prong connectors.
Have had them for over 6 mos. before installing...they won't take them back...understood.
But looking deeper into this, MANY online car places are selling the 3 prong for my vehicle....
do I have a rare bird or??? the OEM is
30520-RRA-007
but good golly they are proud of them...anyone know an aftermarket K-series? coil with 2 prongs?
And they turned out to be too big and with 3 prongs instead of my 2 prong connectors.
Have had them for over 6 mos. before installing...they won't take them back...understood.
But looking deeper into this, MANY online car places are selling the 3 prong for my vehicle....
do I have a rare bird or??? the OEM is
30520-RRA-007
but good golly they are proud of them...anyone know an aftermarket K-series? coil with 2 prongs?
If you think a good mechanic is expensive, try hiring a bad one
Joined: Dec 2011
Posts: 32,017
Likes: 256
From: Midwest. Aiming about mid-chest
Rep Power: 519 
Re: Different ignition coils on Si?? Summit Stinks!
do I have a rare bird or???
30520-RRA-007
30520-RRA-007
It's probably just poor cataloging by various seller(s).
The Honda part number you listed was used on a metric crapton of K engines throughout the years.
There were only a few early Civic (USA-SI and Can SI-R) that used the K engine, but there are a zillion regular Civics that didn't.
