Problems with Avic-N1
#1
Registered!!
Thread Starter
iTrader: (12)
Join Date: Jul 2003
Location: West Coast
Age: 42
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Problems with Avic-N1
Sometimes it turns on and sometimes it doesnt. It'll turn on after I remote state my car and then fold out and in and then not turn on after that. So there is power going to the unit but it wont turn on. It worked fine yesterday after I installed it. Anybody went through a similar problem?
#3
well it could be you're remote cable or ACC cable might not be connected good enough
trust me i had a monitor and and a seperate dvd pioneer radio and that runs so much cables that my 02 civic dash almost pop on my face lol try to shorten the cable but still. so check in with the remote (dark blue cable)...
trust me i had a monitor and and a seperate dvd pioneer radio and that runs so much cables that my 02 civic dash almost pop on my face lol try to shorten the cable but still. so check in with the remote (dark blue cable)...
#7
Registered!!
Thread Starter
iTrader: (12)
Join Date: Jul 2003
Location: West Coast
Age: 42
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Now I have a different problem... The screen keeps going into test mode. Sometimes it wont sometimes it will. When i put the navigation disk in, it goes into test mode. You cant use any of the controls while its in test mode. Anybody else have this problem?
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post