POST your RMS wattage of your system!
Registered!!
Joined: Oct 2004
Posts: 437
Likes: 0
From: Chicago
Rep Power: 268 
Originally Posted by tbaleno
1050W Rockford,
2400W PPI
400W alpine
2400W PPI
400W alpine
Registered!!
Joined: Mar 2004
Posts: 677
Likes: 0
From: Northern MA
Rep Power: 0 Well on the stock battery I dropped down to 9V for a burp (battery died in less than a year) I replaced it with a larger battery and now the voltage only drops to about 11.2V.
I haven't upgraded my stock electrical (search on big 3) wires yet and I'm hoping to see some improvement when I do that.
I haven't upgraded my stock electrical (search on big 3) wires yet and I'm hoping to see some improvement when I do that.
Registered!!
iTrader: (18)
Joined: Feb 2004
Posts: 4,209
Likes: 0
From: La Puente (626), California
Rep Power: 314 I have a total of 4 amps:
(2) 80w x 4 amps for my components (front, Rear, and Center)
and
(2) 500w x 1 For my 15" sub (1 amp on each voice coil)
All Alpine of course.
(2) 80w x 4 amps for my components (front, Rear, and Center)
and
(2) 500w x 1 For my 15" sub (1 amp on each voice coil)
All Alpine of course.
Subarus FTW I do NOT miss my civic
iTrader: (9)
Joined: Jul 2004
Posts: 4,595
Likes: 0
From: Scottsdale, AZ
Rep Power: 0 about 350 rms for the subs. Cant pound my kids ears to death.
I have 2 10" G&S Designs subs, a 600W RF amp. the amp is like half way turned up, so I figure I got about 3-350 RMS. My subs only say 250 watts on the box. so that has to be 500 max for both @2 ohms.
I have 2 10" G&S Designs subs, a 600W RF amp. the amp is like half way turned up, so I figure I got about 3-350 RMS. My subs only say 250 watts on the box. so that has to be 500 max for both @2 ohms.
Last edited by 2K1Civic17"Gabe; Dec 13, 2004 at 02:53 PM.
Registered!!
Hey! Look At Me!! I'm a Supporting Member!!
Joined: Feb 2002
Posts: 85
Likes: 0
From: Phoenix, AZ
Rep Power: 0 
JL audio 450/4: 125w RMS to the front 5 1/4" JL XR comps. 100w RMS to the rear 6 x 9 JL Audio VR.
Rockford Power BD1000.1: 800w RMS to 3 JL Audio 10w3's @ 2.33ohms
Just upgraded my battery to a Exide 34XCD. I also have a 1 farad cap.
Rockford Power BD1000.1: 800w RMS to 3 JL Audio 10w3's @ 2.33ohms
Just upgraded my battery to a Exide 34XCD. I also have a 1 farad cap.
Joined: Jul 2003
Posts: 30,677
Likes: 1
From: Dallas, PA
Rep Power: 609 
1000w xtant for subs
4 x 75 xtant for mids/highs
so..........1,300
who knows for bench tested RMS.......prolly around 1,500-1,600
4 x 75 xtant for mids/highs
so..........1,300
who knows for bench tested RMS.......prolly around 1,500-1,600
367 watts from a Kicker DX350 running to a 2 ohm Kicker 10" round Solobaric
280 watts from a Rockford Fosgate Punch 60x2 running to Infinity Kappa 4" components and infinity Kappa 6½" coaxials
637 total watts
280 watts from a Rockford Fosgate Punch 60x2 running to Infinity Kappa 4" components and infinity Kappa 6½" coaxials
637 total watts
7thGen's Loudest Civic...4,000 watts and climbing...
iTrader: (2)
Joined: Sep 2004
Posts: 1,122
Likes: 0
From: San Antonio, TX
Rep Power: 0 the 'Vic's system has been yanked out (again), but the pair of KX1200.1s and the pair of S15L7s are going in pretty soon, along with the 8 KX60s and the pair of KX350.4s (among other things...just received $7250 from the USAF...time for my early Christmas presents 
)
as you can tell, i love Kicker...my biggest setup so far has been four S15L7s (33 cubic foot ported box) in my truck...approximately 5640 watts courtesy of 4 Kicker KX1200.1s...i had a pair of K65.2 components in each door pushed by the KX350.4s, which were rated around 90 x 4, so i reckon that's another 720 watts or so...so i guess that's 6360 watts at any given time...not too shabby...
i had a Red Top under the hood, 4 Yellow Tops in the back, a nice beefy Ohio Generator alternator, and 0/1 ga. Big 3 upgrade...needless to say, i had no power dips ...
wish i could fit all that $hit into the 'Vic...it would probably peel the trunk off the hinges...
)as you can tell, i love Kicker...my biggest setup so far has been four S15L7s (33 cubic foot ported box) in my truck...approximately 5640 watts courtesy of 4 Kicker KX1200.1s...i had a pair of K65.2 components in each door pushed by the KX350.4s, which were rated around 90 x 4, so i reckon that's another 720 watts or so...so i guess that's 6360 watts at any given time...not too shabby...
i had a Red Top under the hood, 4 Yellow Tops in the back, a nice beefy Ohio Generator alternator, and 0/1 ga. Big 3 upgrade...needless to say, i had no power dips
...wish i could fit all that $hit into the 'Vic...it would probably peel the trunk off the hinges...
The LA Clipper
iTrader: (1)
Joined: Jul 2002
Posts: 5,539
Likes: 0
From: SoCal, California, US
Rep Power: 347
Originally Posted by MegaHurtz
hey fonto cheated you can't count your bridged power if you are running in stereo 
i boogie for the raindrops
Joined: Oct 2001
Posts: 4,497
Likes: 1
From: Jackson, Mississippi
Rep Power: 0 1600+ rms to 1 15"
150 x 2 to 6.5"
80 x 2 to 4"
80 x 2 to tweeter
so to power USED standards, its
2200+ rms
but to people here's cheating standards =) with doing bridged ratings its 2600
150 x 2 to 6.5"
80 x 2 to 4"
80 x 2 to tweeter
so to power USED standards, its
2200+ rms
but to people here's cheating standards =) with doing bridged ratings its 2600
