Rep Power: 0

Alright here´s the story, I bought my self a 1996 honda civic ex with a D16Y7 ENGINE, SINGLE VTEC TRANNY, D16Y8 wireing AND P2P ECU. The problem I have is that i cant take the car passed 5600 rpm and it starts to 2step. So what I did recently was buy an P2E ECU which is the ECU for the D16Y7. I put it in this morning and the car kept turning off. So what I did was adjust the idle and then it finally stayed on and idled. Now the problem I have is that when I rev the car it hesatates between 1200 RPM and 2k RPM, but can finally take it to 7k RPM when I rev it all the way like it is sepose to. So what I did is put in my p2p in and readjusted the idle and it ran perfect but I can not take it passed 5600 rpm so its the same as before. So what I want to know is do I have to adjust anything else so its can run normal, or what do I have to do?
I dont know if this is the same as b20vtec.com but please BUMP is you viewed. Hit me up if its a long process on aim VTEC EJ8 201


Heres an example of what it is doing.
http://www.youtube.com/watch?v=JGAJ7w2OJrg
http://www.youtube.com/watch?v=W_F_i40DrqQ

 
Rep Power: 0

1st Bump

 
Rep Power: 266

Copy your original post and post it in the tech support section instead of here. It gets more views. I can't answer it, sorry.