Rep Power: 0

Ok here is what i got (Pic available) im wondering what the "O" ring is that the instructions talk about. Tell me if im missing something. Thanx

PS. if you ask, yes i got them used

 
Rep Power: 318

the O ring is a rubber ring, maybe 1mm thick and about 2 or 3 inch diameter... i don't really understand their purpose.. when i installed the ground controls for a friend I didn't use them, so you should be fine

 
Rep Power: 0

I think its a little rubber ring almost like a rubber band that slips around the factory strut and then the coilover sleeve slides(not easily) over the ring. This helps prevent rattling from the metal sleeve on the strut. You kinda have to take a flat head and push the oring up between the sleeve and the strut...hope that helps if not email me at rowdyb7@hotmail.com

 
Rep Power: 0

thanx to both of you, i think its enough for me to decide that i will go WITHOUT those "O" rings. I dont have them anyways, so i wont be using them..I will provide pictures when i finish tomorrow.

 
Rep Power: 0

the O-ring goes on the shocks, it secure the sleeve thread so it wont move up and down