Rep Power: 0

I have a 2002 EX. I was thinking about installing some APC reverse indiglos. I took the cluster out and once I looked everything over, I realized that the only way to install the gauges was to remove the needles, something I’m not about to mess with. I’ve heard of to many bad things happening to people who remove their gauges. So I close everything up and put every thing back just the way I found it. But now, my speedo is NOT working!!! Every thing else works, oh and the little battery light is on now too!!! What do I do. I don’t think honda’s warranty will cover this coz my car is slammed and I’ve installed a header, intake and full exhaust. If you have any suggestions they would be greatly appreciated!!!

 
Rep Power: 307

i believe there is a DIY on this........research man, research

 
Rep Power: 0

make sure the gauges are taped down nice and good. The needle might be stuck on a piece that's elevated. As for the rest, [IMG]i/expressions/face-icon-small-confused.gif[/IMG]

 
Rep Power: 0

did you try taking them off and putting them back in together again? If it still doesn't work then you'll probably need to bring it to the dealer..

 
Rep Power: 0

it should definitely be covered under your warranty....if they say it isnt, its bullshlt b/c your intake, header, exhaust and spings have nothing to do with it. Just tell them it stopped working all of a sudden