Rep Power: 0

i wanna install my racing seat already but i dunno where to start. its a momo mirage and its sidemount. i have the brackets and stuff but no directions or anything and this is pissing me off. i know 2k2civicballer has evos in so if you hear me(2k2civicballer), help me out. or if anybody else knows what to do, i could use some help.

 
Rep Power: 0

Very easy. You have 4 bolts you need to remove. Two in front of the seat and two in back. These bolts are what is keeping the seat mounted. I think they were 9mm in size. I may be wrong. Go ahead and take the bolts off. Now you are going to be able to take off the seat now but you still have the wire harnest for your seat belt connected. I disconnected the harnest and sliped out the seat just like that. not to hard to do. As for the brackets you have, you might want to make sure they fit perfectly up with the holes. My brackets I had needed a bit of mod's to make the fit. The seat belts for the time, I connected to the sides of the brackets. If you have 4 point belts dont worry. Then bolt the seat back in place. Dont forget to connect the wire harnest again. Good luck. If you need more help just pm me or email.