NEED HELP!
Thread Starter
Search and Learn
iTrader: (34)
Joined: May 2002
Posts: 14,004
Likes: 0
From: 909, Socal
Rep Power: 432 
NEED HELP!
ok i just installed injen cai on my car today. and i have problem.
intake is installed good but my right blinker beats FAST.sometimes it doesnt work . could it be my bulps? or what i cant figure it out
intake is installed good but my right blinker beats FAST.sometimes it doesnt work . could it be my bulps? or what i cant figure it out
Registered!!
Joined: Dec 2001
Posts: 325
Likes: 0
From: Columbus, Ohio, US
Rep Power: 0 It's not the ECU - you need to take a look at where you installed the rubber spacer, make sure it's tight and you put the wires back where they should be, that's what grounds out the lights (and AC compressor and a few other goodies [IMG]i/expressions/face-icon-small-wink.gif[/IMG] ). I had the same problem, that spacer came loose on me. Make sure it's tight!
Registered!!
Joined: Dec 2001
Posts: 773
Likes: 0
From: san diego, California, US
Rep Power: 0 You blinker is blinking fast because either the bulb blew a filiment or it isn't seated properly in the fixture. Pull the light out and then replace it nd see if it solves the problem. The blinking fast is an indicator for the bulbs.
Oh if you didn't reset your ECU after the install make sure you do that.
Oh if you didn't reset your ECU after the install make sure you do that.
