Rep Power: 0

ok i got a question....
when i try to remove my head unit, i get so far until i reach the two screws that hold the head unit inn,
i can't seem to get them off cuz i have noe room? can someone help?
please
[IMG]i/expressions/laugh2.gif[/IMG][IMG]i/expressions/laugh2.gif[/IMG][IMG]i/expressions/laugh2.gif[/IMG]

 
Rep Power: 0

Try this link first http://www.7thgencivic.com/diy/radio.cfm

But I think I know where your having trouble. When it comes to getting the whole HU and area off.
All you need to do is get something behind the lip where the plastic trim of the HU and AC/Temp controls meet the dash. And then just give a bit of a yank, there are 5 clips that hold the whole thing on. You will need to give it a good pull to get it off but then you can access the whole thing and work away, rather than trying to get to it from reaching up and under.

I know how you feel I did the same thing too.
Good Luck

Crashoveride

Added am image to help.


Attachments:
[IMG]/forums/themes/orbitz/paperclip.gif[/IMG] image2.jpg (49 Kb)

 
Rep Power: 0

what you need to do is get an 8 mm socket up there and unscrew it , its not that hard, then you do have to push rather hard and pop it out .. if ya need help go to the DIY ..

 
Rep Power: 0

If you ask another stupid @$$ question like this again w/out looking @ the DIY's, were going to have to shoot you.

 
Rep Power: 0

look man i did look at the stupid DIY and it didn't show how to get the screws off .
i am not stupid. i did look..[IMG]i/expressions/face-icon-small-mad.gif[/IMG]

 
Rep Power: 0

link, been posted already, but I'll do it again. Whats not to understand. Two screwes come out and you pull hard.

 
Rep Power: 0

if you replace the head unit on an EX or any other 2k1 civic with remote entry, will the remote entry still work, i've heard that it won't if you replace the head unit.