You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join civicforums.com today!
1. First of all make sure you've got the vafc installed the way that apexi had it to begin with. (install it according to the original diagrams.)
2. Disconnect the pink wire (vtec solenoid signal output) from the green/yellow wire (vtec solenoid output.
3. Crimp (DO NOT SOLDER, it melts the diode) the side of the diode with the printed bar on it to the green/yellow wire.
4. Now crimp the other end of the diode to the pink wire so that you've got something that looks like the second diagram that i posted above.
5. Close everything up make sure your connections are crimped tight. Here are the settings i'm using:
V/T cont: Lo >>> Hi = 4500 Hi >>> Lo = 4200
Wide Thr: +3@4500rpm +4@5000rpm +5@6000rpm
everything works great for me. Here is a video of the vtec engagement. If you listen carefully you can hear vvvrrrrVVVRRRR on the first pass right before i get to the light post (i let off the gas 2 sec after it engaged). VIDEO
To remove this ad, register today for free or log in if already registered!
Last edited by Derek-CEO; 05-17-2004 at 06:34 PM.
Sponsored Links
To avoid seeing this ad in our forum please register at CivicForums.com
By joining our free community you will have access to post topics, respond to polls, upload content and access many other special features.
A'PEXi VAFC Install #2 
