ACT clutch installed, *PICS*
 

ok so me and two of my friends did my clutch in his garage on new years eve, im going to make a DIY but dont have the time right now, here are some pics of the install. if you have 2 or more people, and the right tools, its a 5 hour job and not too much of a hassle. if your gonna do it by yourself forget about it. btw, the act clutch is awesome.

removing CV shafts
http://www.7thgencivic.com/memberrid...0_0447-med.JPG

removal of starter
http://www.7thgencivic.com/memberrid...0_0449-med.JPG

http://www.7thgencivic.com/memberrid...0_0450-med.JPG
bell housing bolts

http://www.7thgencivic.com/memberrid...0_0455-med.JPG
rear motor mount

http://www.7thgencivic.com/memberrid...0_0457-med.JPG
flywheel
http://www.7thgencivic.com/memberrid...0_0463-med.JPG

installing act

http://www.7thgencivic.com/memberrid...0_0468-med.JPG release bearing

http://www.7thgencivic.com/memberrid...0_0472-med.JPG
diy coming soon

nice :tup: i have the same clutch and it is awesome

nice pics and congrats on the install :tup:

My stock clutch seems to be making some grinding noises now and again, and also the pedal takes on heavy vibration at anything over 3200 RPMs, has anyone else experienced these type of probs? i have a 2001 EX with about 50000 miles on it.
BTW nice set up im impressed!

Nice!!!! I'll be waiting for the DIY... :tup:

thank you god....I NEED a DIY, I'm doing miune VERY soon

cool :tup:

nice car, nice clutch. So freakin clean!

edit-finally reached 1000 posts! hell yeah

nice car.....add me to the list waiting for the DIY :)

nice car, i wish i had a garage

thanks guys, the next chance i get im gonna sit down and write that DIY as best i can, there were alot of details. btw, here are the tools we used, i wish they were mine!

so you just pulled the starter and axel and swung the bell housing to the side? I had to drop my sub frame when I did a tranny swap to mine. what a pain in the @$$. Was it tough to get the flywheel and clutch off with that small space? and how did you get the bearing out?I thought it would be a pain the pull the bearing like that.

we only had about 5 inches between the trans and motor to work with, im getting ready to make the DIY now, you can read that

how the hell do i post in the DIY section???

I think you have to post in a forum and it gets moved in to the DIY section once its deemed worthy.....make it a good one bro!

ok the DIY is done, eveyone check it out http://www.7thgencivic.com/forums/sh...02#post2665902

despite all the crap about SF. everytime i see the kit, i still wish i was one of the lucky ones to buy and get a GOOD WORKING KIT WITH ALL THE PEICES, before he went under.