Setting Threads http://s22.postimg.org/scm2wblbh/IMAG0320.jpg http://s22.postimg.org/uemkakjal/IMAG0321.jpg http://s22.postimg.org/v5fagclnx/IMAG0329.jpg I screwed (no pun intended) up the threads inside the hole for the bolt for a front engine motor mount. How do I fix this and if I take it somewhere what do you suspect it will cost me? Thanks. |
Re: Setting Threads I would re tap it. There also thinks called Helicoils for fixing threads. I have never used one personally. |
Re: Setting Threads You have to run a bottom tap through it and re-cut the threads. A heli-coil may not be necessary. You'd have to tap it before installing a heli-coil anyway. Do a part lookup on the motor mount bolt, as if you were going to order one. It will tell you the thread size. Get the same size tap from harbor freight, northern tool, or whatever store you want. Run the tap through slowly. As you run the tap through, when it feels tight, reverse direction a turn or so. Its cutting the threads, so when it gets tight, back up, don't keep going or you may break the tap. Then you'll have a tap to remove before you try it again. See if you can find some videos on youtube to watch about tapping. |
Re: Setting Threads Use an oil while running the tap! |
All times are GMT -5. The time now is 02:21 PM. |
© 2024 MH Sub I, LLC dba Internet Brands