Jdm b18c help!
 

I recently purchased a JDM B18C complete swap over from Hmotorsports to put into my 94 Hatch. The motors in and in place but i'm having a few wiring issues. Since the motor is from japan and some of the sensors/plugs are on opposite sides of the car i was told to use my old wiring harness from my D16. I have a few sensors that don't line up quite right and a few that have no where to plug and im stuck at this point and would appreciate any help! Thank you!

Re: Jdm b18c help!
 

Do you have any pics? What sensors are they?

Re: Jdm b18c help!
 

As of right now, no. The cars at my school ill post pics tomorrow

Re: Jdm b18c help!
 

Well, without really seeing it I'd say you might have to lengthen some of the wires to reach the sensors. Using the proper gauge wire solder/splice and shrink wrap the wires until the sensors reach. The few that have nowhere to plug...you'd have to figure out what they are for on the D16 harness and whether you're B18c even has the sensors for them.

Pics of the unknown sensor plugs would help a lot.

Re: Jdm b18c help!
 

Well I figured out where all the sensors go. The car won't start now tho. When I turn the key the tach jumps to 3500rpm and there's no crank. The starter is still getting power though.