HELP PLZ...i'm runnin out of time ok so i got everything off...now the only thing that is pissin me off is the two screws holdin the rotor on. i cannot get it out. i been at this for an hour and a half already. also i spray a whole lot of wd-40 too. plzz is there any trick. i tried bangin one of the screws out and it didnt even move 1/8 of a circle. :hithead: |
Re: HELP PLZ...i'm runnin out of time anyone....ahhhhh soo frustratin...=[ |
Re: HELP PLZ...i'm runnin out of time i assume you're using a philips scredriver...find a flat tip that's just wide enough to fit the screw, put a set of vise grips on it and turn it that way. even better if you have a ratchet and some screwdriver bits, you can put a little more torque on it without worring so much about it slipping cause you can really lean on it better. good luck man, i went through the same problem when i swapped out my rotors. |
Re: HELP PLZ...i'm runnin out of time get a screwdriver that fits and a small mallet. Tap as you unscrew |
Re: HELP PLZ...i'm runnin out of time arghh..jus finish puttin on the ss brake lines...still stuck on the screws...fuk! ty for the advice though guys i appreciated. |
Re: HELP PLZ...i'm runnin out of time Impact screwdriver. And don't worry about putting them back on, just remember when you take your wheels off the rotor will be loose. |
Re: HELP PLZ...i'm runnin out of time
Originally Posted by bobsagator
(Post 4167002)
Impact screwdriver. And don't worry about putting them back on, just remember when you take your wheels off the rotor will be loose. http://www.harborfreight.com/cpi/pho...7599/37530.gif |
Re: HELP PLZ...i'm runnin out of time impact driver is the only way your gonna get those screws out unless you are the Hulk |
Re: HELP PLZ...i'm runnin out of time You could always drill out the screws, you dont need them. |
Re: HELP PLZ...i'm runnin out of time ty for all the advice guys, and after doing the rotor swaps. i HIGHLY recommend gettin the IMPACT SCREW DRIVER. simple and easy, and no hassle. |
Re: HELP PLZ...i'm runnin out of time Another trick for getting those stubborn screws off, if you have a small drill bit, drill a small shallow hole in the center of the screw, if you get some of the metal out of the center, the bit fits better in there. Or if you have a dremel type tool, you can cut a flat slit in the head of the screw to fit a larger flathead in there. Or you can just curse at it until it cowers in fear. I've done that before, ha ha, jk. I was working on an exhaust nut that would'nt come off of this Mazda, so I just cursed at it and cranked a vice grip on it, it broke the vice grip. So me and my father had to get one of those stripped nut ratchet head kits to get it off. It was a BEEACH! nuts and bolts are a pain is the ass, but hold the whole car together. |
Re: HELP PLZ...i'm runnin out of time yea...wish they would come out wit better product...stupid ass wd-4o dont do shit! |
All times are GMT -5. The time now is 08:39 AM. |
© 2024 MH Sub I, LLC dba Internet Brands