some ECU wiring quetsions... ok reading the post "2001-2003 civic ecu diagram" (http://www.7thgencivic.com/forums/sh...ressure+switch), i found a few things that seemed interesting ( :susp: )but have no idea what it means. i was wondering if you guys could clear it up for me. heres the stuff i DONT understand/know: Connector B (24 Pins) 7-red/blk-A/T Pressure control solenoid valve A 9-blu/blk-VTEC Oil pressure switch VTEC ONLY 16-blk/red-A/T Pressure control solenoid valve B 21-yel/blu-EVAP Canistor purge valve Connector C (22 Pins)– AUTO TRANSMISSION ONLY 4-grn/wht-Shift solenoid B 6-blu/blk-Shift Solenoid A Connector E (31 pins) 20-blu/red-EVAP bypass solenoid valve 21-lt grn/red-EVAP Canister shut valve anyone got any ideas on what these things mean? thanks! |
The VTEC switch is what engages VTEC.... its the signal to open the oil line to engage the secondary lifters... its looking for a PSI value that the computer puts with the other necessary parameters then triggers it. The 2 on C are the solenoids that trigger gear changes... basically those are how the computer controls the AT. The EVAP ones are for the charcoal canister. Its part of the emissions system, but I don't know really what it does. |
What about Connector A: 6-wht-Primary O2 sensor I can't find it! wht does mean white, correct? If so, I don't have a white wire coming into my connector A. |
Well it depends which you think is connector A. I found out the hard way that E is on top and A is the bottom one. |
ah crap. I took all the connectors out and I was examining them all. I couldn't find a white wire. lol, maybe I'm just not look hard enough. Thanks for the tip, though, Boilermaker1. I'll go try and finish what I started. |
Originally Posted by Boilermaker1 The VTEC switch is what engages VTEC.... its the signal to open the oil line to engage the secondary lifters... its looking for a PSI value that the computer puts with the other necessary parameters then triggers it. The 2 on C are the solenoids that trigger gear changes... basically those are how the computer controls the AT. The EVAP ones are for the charcoal canister. Its part of the emissions system, but I don't know really what it does. would tapping this line similar to how you tapped the VTEC solenoid be somewhat "good" to determine the VTEC activiation point? |
*bump |
All times are GMT -5. The time now is 10:52 PM. |
© 2024 MH Sub I, LLC dba Internet Brands