DIY Fuel Door Fix Coupe! ( I apologize for the dim lighting in advance ) THIS DIY IS USING "www.fueldoorfix.com" 's Canadian piece to fix the door Tools needed: 1. 10 mm ratchet 2. 14 mm ratchet 3. Phillips head screw driver 4. 2 flat head screw drivers 5. 2 aspirin http://i25.photobucket.com/albums/c9...0fix/tools.jpg pry off the lock cover carefully, (i cracked mine), use 2 flatheads, insert one into obvious hole on top and the other right next to it. pry up and towards the inside of car until it pops off http://i25.photobucket.com/albums/c9...ix/cracked.jpg use phillips head to unscrew screw next to lock http://i25.photobucket.com/albums/c9...ix/unscrew.jpg use flat head to pry cylindrical, silver lock out http://i25.photobucket.com/albums/c9...x/sideways.jpg http://i25.photobucket.com/albums/c9...20fix/lock.jpg lets remove the seatbelt now, it's heavy and can be useful for weight reduction, OR TRIM REMOVAL. first pry off plastic center cap on bottom of driver side seatbelt harness. Be careful it's plastic and can snap. next use a 14mm ratchet and remove bottom of seatbelt http://i25.photobucket.com/albums/c9...beltbottom.jpg http://i25.photobucket.com/albums/c9...x/seatbelt.jpg removed, now you'll be able to remove both pieces of trim for easy access to fuel door lever next your going to remove the trim surrounding your hood release. theres 2 plastic clips to release. The white circle clips, 1 top 1 bottom in pic below http://i25.photobucket.com/albums/c9...x/footrest.jpg http://i25.photobucket.com/albums/c9...opfootrest.jpg http://i25.photobucket.com/albums/c9...omfootrest.jpg pull trim from top first, out and towards the rear of the car. then pull bottom of trim piece the same way. You have to do this to avoid breaking the clip because of the slot the white clip slips into on the trim shown below: top: http://i25.photobucket.com/albums/c9...20fix/clip.jpg bottom: http://i25.photobucket.com/albums/c9...insulation.jpg http://i25.photobucket.com/albums/c9...ix/removed.jpg the next piece of trim you remove is the running board, i guess you could call it. This is why you detached the seatbelt. CAREFULLY slide your fingers under the outer edge and begin to pop out clips: http://i25.photobucket.com/albums/c9...nningboard.jpg as you can see below, there's 4 clips to pop out on top*, then theres like 4 more on the back inner trim wall. These are the clips you have to slide a certain way or they'l break, (which mine did). Try and pry off and slide toward the *rear*(*i think ==>to check it, the slide holes on the back trim wall should be in the opposite direction as the white clips on top(4)*), pushing a little towards the inside of your car. http://i25.photobucket.com/albums/c9...gboardfull.jpg with that removed you should see the lever setup. It's attached to the inner edge with a 10 mm bolt you need to undo (top left in pic), heres a pic of the inside of the setup: http://i25.photobucket.com/albums/c9...insidebolt.jpg http://i25.photobucket.com/albums/c9...rokencable.jpg http://i25.photobucket.com/albums/c9...okencable2.jpg attach your Canadian black snap-on piece to the 1st white circle and around the wire, snap on other half and test it before putting everything back together. Once it works put back on all the trim and go show off your working fuel door! http://i25.photobucket.com/albums/c9...or%20fix/1.jpg http://i25.photobucket.com/albums/c9...lledpart-1.jpg NOTE: when re-installing the 10 mm bolt, be careful where exactly you position it because it will affect if the lever rubs against the housing when lifted. :_beer: |
Re: DIY Fuel Door Fix Coupe! AHHH u used the part from fueldoorfix.com nice diy +1 for the coupe install. How about mine? |
Re: DIY Fuel Door Fix Coupe! Yeah, I just used the fix on my car on Saturday. Worked like it was supposed to. Really easy to do. |
Re: DIY Fuel Door Fix Coupe! bookmarked thanks man! |
Re: DIY Fuel Door Fix Coupe! Did This, Worked As Stated, My Only Addition Would Be That Those Who Live In The Salt Belt Check The Cable End Where It Goes Into The Release Handle As It Expands, It Corrodes, So Causes Sticking Between The Handle And The Cable End. Clean As Necessary To Bring Back Proper Fit. |
Re: DIY Fuel Door Fix Coupe! Completed this project yesterday! Followed DIY and was so simple! Thank you so much dryft for the awesome write up. On a side note....the FUELDOORFIX product is kick ass.....what an awesome fix! |
Re: DIY Fuel Door Fix Coupe! really good i was having this probelm and the boot too and now i can go fix this. |
Re: DIY Fuel Door Fix Coupe! I actually fixed that plastic piece myself with thread and super glue - you take about a foot of heavy thread, and glue an end down. Then, wrap the thread tightly around the part, kind of like you are putting thread on a spindle, tight and close. After each layer of thread, saturate with super glue. Thread + superglue roughly equates to concrete. Very handy for small plastic parts that dont need to do much. Worked fine for a couple months, until the actual cable itself busted off due to the stress of the angle it is at when held in place. Turns out, that plastic piece of crap was the strongest piece of that assembly once I got through with it, so all the stress went to the cable and it finally busted off. Check your cable for signs of cracking or fatigue. You might be closer to a full replacement of the part than you think. |
Re: DIY Fuel Door Fix Coupe! Wut is this? Confusing Me.. |
Re: DIY Fuel Door Fix Coupe!
Originally Posted by GreenMachineDX
(Post 4436940)
Wut is this? Confusing Me.. This is a quick and easy fix for the problem. |
Re: DIY Fuel Door Fix Coupe! Oh Ok... Well, I dont have this problem yet... But its good to see there is a diy for this fix.. |
Re: DIY Fuel Door Fix Coupe! thanks, Ive got the same problem. maybe this video will go along nicely with your DIY http://www.youtube.com/watch?v=5-ovIXM6pX4 |
Re: DIY Fuel Door Fix Coupe! im going to try some type of home made job, maybe some wire or something, I'll get it too work. Don't feel like ordering a new cable OR that fix kit. $90CAD for the cable from Honda |
Re: DIY Fuel Door Fix Coupe! its interesting how one cable works for both trunk and fuel door... |
All times are GMT -5. The time now is 05:07 AM. |
© 2024 MH Sub I, LLC dba Internet Brands