shaved, Trunk/Doors
That looks neat. This is something that has always fascinated me, and left me stumped at the same time, how do you go about doing this? Removing the door handles etc... And then, how do you open the door? 
Thread Starter
ish...
iTrader: (2)
Joined: Dec 2002
Posts: 826
Likes: 0
From: Guadalajara, Mexico
Rep Power: 0 
They did this:
1.- Remove Handle
2.- Solder a piece metal covering the handle "hole"
3.- Sand it a lot
4.- Fix the line of the car
5.- Sand again
6.- Paint
To open it:
Just used Solenoids and a remote control
1.- Remove Handle
2.- Solder a piece metal covering the handle "hole"
3.- Sand it a lot
4.- Fix the line of the car
5.- Sand again
6.- Paint
To open it:
Just used Solenoids and a remote control
Originally posted by Jaykuai
I Guess....
I will have a "secret" cable to open the hood by the bumper.. THEN
I would have to replace the battery..
I Guess....
I will have a "secret" cable to open the hood by the bumper.. THEN
I would have to replace the battery..
muHAhahahh! 
Joined: Sep 2001
Posts: 3,101
Likes: 0
From: Los Angeles, CA
Rep Power: 0 
Originally posted by hassoomi
so fresh n so clean!
so would something like this actually make it harder for a thief to get in?
so fresh n so clean!
so would something like this actually make it harder for a thief to get in?
Reppin Stage 7
Registered!!
Joined: Dec 2002
Posts: 1,447
Likes: 0
From: San Diego, CA
Rep Power: 0 
it's settled, then; i'm going down to mexico to get any work done on my car. actually, if you could suggest a good shop that's near the border with san diego, that'd be awesome. looks like they did a REALLY good job Last edited by hassoomi; Jun 2, 2003 at 12:29 AM.
