Rep Power: 0

hi, i am going to make a full stainless steel exhaust for ep, em, and dc5. its going to be one piece with a "jic style" muffler. the price will be around $320 US. really cheap price for a one piece stainless steel design.

how many people will consider buying this?????

 
Rep Power: 0

I'm down if the system is a full mandrel bent, no bottle necks, 60 mm. NO LARGE TIP!! 3in is pretty dog gone big. And a quiet system is also required. Great price range though.

 
Rep Power: 369

same requirements as above.

and it should clear a thicker sway bar... and if the car is lowered..

tough to design but yeah.. gotta have to clear the rear sway bar.. some of us have 19mm or 22mm instead of the stock 12/13mm

and some of us lower our rides too...

 
Rep Power: 0

Sounds interesting, I might be interested. Pondering a new exhaust, but none out now seem that appealing.

As another poster said, no large tips! Egad I can't stand huge tips for something that only gives like 2-5 hp. 2.5" tip would be the best.

-Aki

 
Rep Power: 0

i would buy it. just want to see pics when it is done.

 
Rep Power: 0

FROM SELLER:

it is going to be full-madrel. piping are 2.25" for em,ep, and base dc5. 2.5" for dc5 type-s. and yes, i will design it to fit with the thickest of swaybars. the tip is very mild and conservative (not those old school 4" on supra's). are far as the sound goes, it will be an agressive sound. that is the whole mission statement of my products, "all race".

i need to see what people think os this product. because buying the materials to make it is a pretty big investment for me.

 
Rep Power: 0

If you follow the guide lines we have set, you'll get a big demand for your product. Just be sure to have a quality part, and good customer service. I can't emphasize that enough. Also, Gas Tungston Arc Welding (TIG) is a must for a great looking/quality exhaust. Hope you can weld