Rep Power: 235

Was only installed on the car for 2 months. I'm selling it to get a little more cash for college. $70+shipping or Best offer. Also open to trade.

 
Rep Power: 282

did you cut the left side and the rear by yourself?

 
Rep Power: 235

yea, thats why I took pictures of those sides. $90 and They didn't even cut all the holes so it would fit...

 
Rep Power: 282

What did you use to do it if you dont mind me asking?

I agree they should cut those parts in production, I know they have the tools. I had to modify my pin mounts that connect it to the valve cover, because the holes for them are too small. I dont let small things like that stop me though. Took a couple hours but my pins fit perfectly.

Good job on the cut, and good luck with the sale!

for people looking into it, this product is durable and withstands heat from the engine. Since his is cut it will be a direct fit!

 
Rep Power: 235

i actually used a miter saw the first time (i wouldn't recommend that to anyone.) Then i went back through with a dremel tool that i found and cleaned it up. The dremel was the way to go. I also used it for those pin holes too, they were crazy small.
Did you have to wait like over a month to get yours?

 
Rep Power: 282

yeah and I was told it was only 1 lady doing all the work. Communication was poor.

For the cost and wait, they should cut those pieces out for customers.

 
Rep Power: 235

bump

 
Rep Power: 258

this hasnt sold yet? If I had a d17 still I would have picked this up in a heartbeat...very nice!

 
Rep Power: 239

If you can sell it for 70 shipped to AZ, I'll take. Pm and I'll paypal you.

 
Rep Power: 235

cover going to LatinEM2

 
Rep Power: 239

I sent the payment.