Rep Power: 0

Ok guys, I'm putting in my APC show tubes, which in essence is a 4 point roll cage. Well, on the rear deck of the car there is a little ledge where the seats latch when you put them in the up position. Two of the tubes sit on that ledge, and now the rear seat won't close. I haven't installed it yet, I just pieced it together in place. How can I bend the sheet metal inside the seat so I can get it to latch? Or do I even have to do that? APC did not know, and I was wondering if anyone had these. They look really sweet, but it looks like I may have to modify or take out my rear seat now. [IMG]i/expressions/face-icon-small-confused.gif[/IMG]

 
Rep Power: 0

[IMG]i/expressions/laugh2.gif[/IMG]

 
Rep Power: 0

i would classify that as not fitting.

 
Rep Power: 0

Just dont roll your car then you wont have to worry about puttin the bars in

 
Rep Power: 0

[IMG]i/expressions/face-icon-small-puke.gif[/IMG]apc

 
Rep Power: 0

uhhhhhhhhh..... what are you installing ???? anyone got a pic of this madness ??[IMG]i/expressions/face-icon-small-confused.gif[/IMG]

 
Rep Power: 306

show tubes... sorry man, but isn't that like putting type-r stickers on your car when its not a type-r?