Rep Power: 246

alright one of my amps for some reason keeps going into thermal mode when it is not hot, anyone have a reason why this might happen? I am changing the fuses tomorrow but I looked at them all and they seemed fine, if this has happened to you give me some suggestions

 
Rep Power: 322

check your wiring - is your ground solid?

 
Rep Power: 0

lack of ventilation
speaker's impedance is too low for the amplifier
bad ground causing a voltage drop

 
Rep Power: 246

I know the ventilation is an issue but has recently been occuring when the amp is not even hot so it wouldnt be ventilation, i have 2 amps and the speakers work fine with it the wires should be good but the ground could be an issue

I dont think it the ground but I might be wrong

 
Rep Power: 811

chech the ohm load, its prolly wired wrong and lucky for you the amp can shut down instead of blowing up.

 
Rep Power: 246

but if it was wired wrong it most likely would have started this when installed, it has been installed for awhile and this problem just came about

 
Rep Power: 811

hmm, what amp is it? maybe something broke inside? you could always get the amp tested to make sure its not that.

 
Rep Power: 246

rockfordfostgate mp4004 4-channel amp