2004 EM2 Civic Energy bushings problem
#1
Registered!!
Thread Starter
Join Date: Jul 2015
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 2004 EM2 Civic Energy bushings problem
Hi Everyone,
As the title explains, I've run into a wall re-assembling the front end. The control arms with the new bushings are installed in the subframe but I can't get the ball joint back into place. Currently, the knuckle is loosely bolted (both bolts) onto the strut and the sway bar end link is disconnected. Those bushings are incredibly stiff so I can't push the the control arm down enough to clear the 2 inches required to slip the ball joint in.
Can anybody with experience chime in on how it's done?
Thanks in advance.
As the title explains, I've run into a wall re-assembling the front end. The control arms with the new bushings are installed in the subframe but I can't get the ball joint back into place. Currently, the knuckle is loosely bolted (both bolts) onto the strut and the sway bar end link is disconnected. Those bushings are incredibly stiff so I can't push the the control arm down enough to clear the 2 inches required to slip the ball joint in.
Can anybody with experience chime in on how it's done?
Thanks in advance.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
mattdoc
Mechanical Problems/Vehicle Issues and Fix-it Forum
9
03-14-2017 12:10 PM
chgofirefighter
Archive - Vehicles for Sale/Wanted
0
04-18-2015 08:08 PM
GH04si
Mechanical Problems/Vehicle Issues and Fix-it Forum
3
04-15-2015 08:13 PM