Rep Power: 453

Ok, I recieved my service manual today and was curious about the tool information. Say like on page 6-13 for the crankshaft pulley removal and install, it list the special tools required, but I dont understand how they do it, or which tool to get.

They say

holder handle 07JAB-001020B
Holder attachment, 50mm, offset 07MAB-PY3010A

Now what do the numbers represent and letters represent? And if I wanted these tools to remove the pulley, what would I ask for at a tool place, a holder handle and holder attatchment? Or would I go by those numbers?

Where are you gearbox to answer this for me?

 
Rep Power: 307

Those are the HONDA part numbers.

But Snap on probably has them for cheaper if you can believe that.

 
Rep Power: 453

Would I still use the same part numbers if I went through Snap on? Or if say I went to sears and got those parts?

 
Rep Power: 812

Yeah there is a special pulley removal tool that many places sell. It's a generic tool, or you can buy the Honda ones using their order numbers. It's basically a tool that keeps the crankshaft from rotating while you loosen the pulley.

 
Rep Power: 812

Here's some reading for ya

http://www.automotiveforums.com/t58070.html