i have a problem
#1
Registered!!
Thread Starter
Join Date: Aug 2014
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 i have a problem
i am installing an 01-05 d15b it wires in the same as a d17 all the wiring from the engine to the ecu are intact but i have one connector on the ecu that was cut and i can't find where the wires go it is connector b can any anyone help with the ansewer
#2
If you think a good mechanic is expensive, try hiring a bad one
Re: i have a problem
Sounds like you are gonna need a good wiring diagram or another engine harness
#3
Registered!!
Thread Starter
Join Date: Aug 2014
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: i have a problem
i found the answer my self i identified the wires just need to figure out how to hook the wires the jdm d15b uses the same pinout as the usdm d17 just a few minor differences i just need to figure out how to hook up the wires i need
Last edited by fierocrazy1; 08-31-2014 at 02:27 AM. Reason: missing one thought
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post