Dx Cx Motors
#1
Registered!!
Thread Starter
Join Date: Apr 2011
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Dx Cx Motors
I had to replace my D15b7 motor out of my Civic Dx. I found a D15B8 from a CX civic. I've noticed that the intake manifold and throttle body are smaller on the Cx's D15B8. Both valve covers say 16 valve. Are there other differences in the heads or blocks?? Should I use my DX's intake manifold only being that its bigger or should I swap the entire head? Any help would be appreciated. Thanks.
#2
Registered!!
Join Date: May 2010
Location: Funkytown, Tx
Posts: 3,662
Likes: 0
Received 2 Likes
on
2 Posts
Rep Power: 210 Re: Dx Cx Motors
Your ECU is set up for the B7, it would probably not run right if you just straight swapped. Not to mention the harness may be different. I would go with the B7 head on the B8 block but, would do more research to be sure. Good place to pose this question: http://www.honda-tech.com/
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
jdawgzcivic
Engine
17
02-01-2020 04:16 PM
ChrisHandHonda
10th Generation Civic 2016-2021
26
09-25-2015 11:28 PM
FistRock
Mechanical Problems/Vehicle Issues and Fix-it Forum
4
09-04-2015 08:00 PM
hatch90
Mechanical Problems/Vehicle Issues and Fix-it Forum
1
09-03-2015 08:45 AM