Demen-t

I have a 2000 civic dx. im trying to do the power locks and windows convertion. so i got the door's harnes's and window regulators from a 2000 civic ex or si (not sure cuz the car was stripped). then i got the door panels, switches, door locks, and the power locks control box of a 97 ex. i do not want to change the dash or floor harness so i followed the diagram below for wiring.
the issue is that i was able to wire all wires from passenger door but theres 3 extra wires on the drivers harness. i think they are from the control box. i do not know whats wrong, my windows work perfectly but my my locks wont work. you could hear the clicking on the control box but it does nothing.
Can someone please help with this? is there another way to make this work with what i have?

asianboy781

u hear the clicking off the relay right
then theres power coming from it
if that is the fact then check the power wires coming from the relay to the locks solonoid

asianboy781

the fuse box of all civic is the same in that year rather if it an si or ex or lx
all 3 have power locks and windows
dx have empty fuse slots but once you plug in the harness just add the fuse

Demen-t

i checked the wires and they are good. the thing is i did a direct wiring without changing the floor or dash harness. there are 3 extra wires from the lock relay i dont know where they go.

asianboy781

ahhn dude take a picture i wanna look at the relay and the wires

Demen-t

ok i took it off the car today untill i figure it out so tomorrow ill take the pics of everything and post them up! thanks

Demen-t

ok so i changed the main harness from the firewall and the floor harness of a 2000 civic si. i also swaped the inside fuse box but not the one under the hood. i believe i added all the required fuses but still my doors will not work. any ideas?