TDC2001civic

Okay so i got my new balljoints pressed into my knuckles and they have a 90 degree zirk fitting threaded into top, but now my cv shaft doesn't seat into the knuckle correctly, anyone have this issue with balljoint replacement?

the balljoints are from autozone

TDC2001civic

who was it that said they had balljoints with zirk fittings? And how did you get the clearance to run them?

lazlong

Zirk fittings won't fit. Grease the joint, then remove the fitting and plug the hole.

link7

I have Moog ball joints on my 2005 ex and I had no problems getting the axle back in after putting the zirk fittings in. I left them in with no problem. I guess it depends which brand ball joints you're using. Dumb question, but are you sure they're pressed all the way in? Are the zirks screwed in all the way?

TDC2001civic

yeah they were pressed in all the way and zirks tightened all the way down, dumb question from ne now lol, is the zirk located on the top of your balljoint with a 90 degree zirk

lazlong

^^ yes

link7

Yes on both