Rep Power: 316

I bought one off a member of this site, went to put it on, and it didn't seem to
fit. The hole in the adapter fits on the hole vacated by the shift linkage, but when
I go to fit the part of the adapter where the screw for the allen key is, it's hitting
up against the curved section of the shift lever. What do I do??

 
Rep Power: 0

Send the adapter to me and then shoot yourself......[IMG]i/expressions/laugh2.gif[/IMG][IMG]i/expressions/laugh2.gif[/IMG]

 
Rep Power: 316

Thanks, APS, I'll think about it

 
Rep Power: 0

sounds like you might have to use a hammer and make that adapter your biiiaaatch.....

 
Rep Power: 0

http://www.madstatic.com/2k1civic/diy/shortthrow/

 
Rep Power: 316

The channel on the DC isn't big enough to fit over the shift lever, since
it's hitting right where the lever curves

 
Rep Power: 0

that's weird. I'm just about to buy the dc ss adapter also. let me know how things turn out. btw, how much did u get the dc adapter for?

 
Rep Power: 413

I bought a used one from this site to and I had NO problems what so ever and I had no idea what i was doing. It is fairly easy.

 
Rep Power: 316

I paid $35 for it. I realize how easy it is to put on, it just doesn't
wanna fit. I'll take a pic of my problem, to explain it better

 
Rep Power: 0

I've got the DC short shift adapter, it was easy to install and I had no problems, make sure you have it all lined up correctly. If i remember the curved part fits on the the shaft of the shifter.