Forced Induction and SwapsPost information/questions about Forced Induction methods (Turbos & Nitrous Oxide) and swaps here.
Welcome to civicforums.com!
Welcome to civicforums.com.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join civicforums.com today!
Someone fill me in. Suppose I got a TiAL 35mm wastegate, they say that you should get a spring a little lower (few psi) then what you plan on running. That way you can use the boost controller to fine tune it. So if I plan on running any where from 5-8psi, what spring would I get? They offer these 2: .3Bar (4.35psi), .45Bar (6.53 psi), which would be of any interest to me. I assume I should use the .3 bar, but is that still going to be ok to use around 7-8psi without having to change out the spring to a .45bar?
To remove this ad, register today for free or log in if already registered!
Sponsored Links
To avoid seeing this ad in our forum please register at CivicForums.com
By joining our free community you will have access to post topics, respond to polls, upload content and access many other special features.
