Forced Induction and SwapsPost information/questions about Forced Induction methods (Turbos & Nitrous Oxide) and swaps here.
Welcome to civicforums.com!
Welcome to civicforums.com.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join civicforums.com today!
I have the K20A2 motor in my 2001 Civic EX Coupe.
Is it possible to use the K20A2 torque dampner, or is there no where for it to bolt up to on the Civic?
Thanks.
To remove this ad, register today for free or log in if already registered!
__________________ K20A (KPRO) 10.5:1 Mahle pistons, oliver rods, cometic head gasket, ARP bolts, KMS 1mm oversized valves, 650cc RC injectors, Port and Polish, All stainless hoses, walbro fuel pump, S2000 oil pump,alternator (190Amp),Turbo intercooled and N'tercooler, turbo timer, Profec-B Spec 2, limited slip, short shifter, lightened flywheel, Drive Shaft Shop stage 3 axels, 17" Trak Lite 2's, Koni Yellows, Tanabe springs, Neuspeed U/L strut bars, Progress Rear sway, Skunk2 custom dual exhaust, sparco torinos, verticle doors
Sponsored Links
To avoid seeing this ad in our forum please register at CivicForums.com
By joining our free community you will have access to post topics, respond to polls, upload content and access many other special features.
