Harness install on Corbreau

[berettagtz117]

Well ineed some help!!! I got my seat brackets in yesterday for My Corbreau CR1's and they went in fine but I could not get the harness's to bolt in because the stock bolts are just alittle to short or something, I dont know if I did it wrong or not but if you could please explain where they bolt up at I have the 4 point harness's just if you could let me know exactly where they bolt down at. I looked at the DIY but it was for stock seats so that didnt help me. Thankyou Here is close to what I have but Mine are Corbreau

To remove this ad, register today for free or log in if already registered!

[sspem2]

i did mine yesterday and my cr1 seats. your suppose to get new bolts. use them. u did get the hardware thats suppose to come with them?

[berettagtz117]

Originally posted by 1siksivik
i did mine yesterday and my cr1 seats. your suppose to get new bolts. use them. u did get the hardware thats suppose to come with them?

No I did not get new hardware I just have the bolts from the stock seats, where did you attach all four harness clips at??

[sspem2]

the 2 that goes thru the seat u attach those where the stock seatbelts are. u gotta remove ur stock back seat. the other 2 up front i attached the one where the stock seat belt is(the thing u clip ur belt into. then the other one i bolted it to the bolt thats holdin the seat. im i makin sense? ok take the drivers side for an example. take the bolt off where u have the stock belt at where u click ur seatbelt i put one there then the two brackets that hold the seat to the floor in the back on the left i put the other one there.

[berettagtz117]

Originally posted by 1siksivik
the 2 that goes thru the seat u attach those where the stock seatbelts are. u gotta remove ur stock back seat. the other 2 up front i attached the one where the stock seat belt is(the thing u clip ur belt into. then the other one i bolted it to the bolt thats holdin the seat. im i makin sense? ok take the drivers side for an example. take the bolt off where u have the stock belt at where u click ur seatbelt i put one there then the two brackets that hold the seat to the floor in the back on the left i put the other one there.

Ok thanks alot now i got it I just messed up with the one where you clip into I tried bolting that one in the back to thats why it wouldnt fit. Appreciate your help

[sspem2]

no problem

[KeNsHiN]

woooohooo another helpful member! thats why i love this site

[sspem2]

Originally posted by KeNsHiN
woooohooo another helpful member! thats why i love this site

i try