RSX rear swaybar installed - Page 4

Grey · 04-28-2002

I calculated that a 22mm rear sway bar is just a little more stiff than it should be for the rear. The 19mm is way too soft. That's if we don't upgrade the front sway bar.

Check this out: SWAY BAR

To remove this ad, register today for free or log in if already registered!

nbpEMCivic · 08-06-2002

Here are the correct part numbers when ordering from http://www.acuraautomotiveparts.net:
35902 - SPRING, RR. (19MM) (need 1)
35948 - BUSH (19MM) (need 2)
35958 - HOLDER, R. RR. (need 1)
35971 - HOLDER, L. RR. (need 1)
Look for the "Rear Lower Arm" section on that site.
Total cost for those parts is $78.37 plus shipping.

Boilermaker1 · 08-07-2002

Hey sicsol... This is great, I'm glad it was tried. Let me just get one thing straight... This is just a direct Swap of the EX bar to the RSX-S bar right? I don't have to move anything or re-drill any holes? I would bet having a front upper strut brace would also help to counteract the stiffer rear right? Last question.. Where is the jack point on the rear end? I can't find it. $79 for parts is much less than Neuspeed will probably charge for the same bar with a logo on it.