Crankshaft pulley bolt

[adamosity]

So, somehow my pulley came loose and when i took it apart i noticed that the woodruf key and the gear around it were chipped. I took off the entire set up down to the rod that goes into the crankshaft. That's chipped too. So do i have to get a whole new crankshaft installed or can i just weld the small area where it is chipped? Any other ways i can get around this problem and any ideas on the costs?

To remove this ad, register today for free or log in if already registered!

[gearbox]

no there is no way to weld it, chances are you will never get it perfect and the crank may vibrate if its not balanced. its gonna cost alot

[amatias]

try call your local junkyard and maybe might get lucky.