Other Honda Civic Parts and ProductsPost new products, talk about parts other than Honda Civic electrical, drivetrain and Suspension. This forum is only for Other Honda Civic Parts and Products.
tanabe SRM cat-back
fit: 4 had to wrap foam around piping against hitting sway bar
power: 1.5~2 can't notice shiet
loudness: 4 loud but was used to it before i took it off
stainless steel, 60 mm in and 100 mm out
5Zigen supposedly,...got on ebay, anyways,
Fit: 4 (Good fit, not rattle on mine)
power: 3.5
sound: 4 (very nice low deep sound, not high and raspy like a lawn mower)
A'pexi GT Spec Catback
Fit - 4 Fits great, no problems. It scrapes sometimes though.
Power - 4
Loudness - 3-5 Depending on if you have the silencer in. got it in and it sounds great
Material - Full SS
Fit - 4 Fits great, no problems. Car was slammed so i scratched it a few times
Power - 3
Loudness - 2 I love the quiet nice tone it gave out
Material - Full SS
price - $490 shipped
#2 Greddy Evo 2
Fit - 4
Power - 3
Loudness - 4 It sounds louder then my Thermal but sounds good still
Material - Full SS (1st Greddy Evo isn't)
Does anyone have an adjusttable exhaust? Can anyone adjust the back pressure on there exhaust?
1994 Civic with B18B1 - Comptech 4-2-1 SS header & 2.25" piping to rear:
Just installed Supertrapp Wavetech tuneable muffler.
*SS construction with super deep tone.
*Add discs to muffler to increase loudness and top end power
*Remove discs to quiet and increase low end power.
If you put in the max number of 12 discs, your car will wake the dead and the interior will rattle.
I have 5 discs in due to the 7000 RPM redline on my engine. It is still loud at wide open throttle, but I can't compare the power difference to the previous Apexi N1 because the motor has been upgraded a little bit more.
where did you get your exhaust, is it cat back and how do you like it compared to a greddy or a dc!!
Quote:
Originally Posted by Boilermaker1
RS*R ExMag
Fit - 5 Fits up in the stock exhaust tunnel, doesn't hit anything, tucks right up under bumper
Power - 3 Midrange help
Noise - 1 Stock with a lower pitch.
Full Stainless, ceramic coated, 60mm piping, 100 mm tip.
Fit 1 to 5: How well does it fit the car without cutting, making new hangers, etc. 1=fit like hell, all the way to, 5=fit tighter than stock without rattle.
Power 1 to 5: 1=less power than stock, 2=about the same as stock, 3=some gains, 4=very noticeable, 5=Feels like its been boosted
Loudness 1 to 5: Volume 1= Quieter than stock to 5= Loud, wakes the neighbors when you get on it.
After the name is the material: SS= Stainless Steel, PS= Stainless can only, AS= Aluminized Steel and then the pipe/tip diameter.
Also if you decide to update your review at any time just insert *UPDATE (and the date)*
__________________________________________________ ______________
*UPDATE 12/18/04*
Tanabe Tuner Medalion - SS (muffler only, custom piping)/2.25"/4"
Fit - - - - - - 4.6 (rattles in heavy rain/going through puddles/deep snow)
Power - - - - 2 (without silencer) 3.5 (with silencer on)
Loudness - - 4.5 (without silencer) 4 (with silencer on)
RS-R ExMag
Fit - 5
Power - 4
Loudness - 2
Um ... steel w/ ceramic coating / chrome tip
Greddy Evo 2
Fit - 2
Power - 2.5
Loudness - 3.5
SS
Tanabe SRM
Fit - 4
Power - 2
Loudness - 4
SS
Last edited by aznboysrfr : 03-09-2005 at 01:59 PM.
RSX Type S Exhaust
Fit 3 - Has to be modified but fit perfectly with no rattles.
Power 3 - Some Increase through all the rev range with no loss in low range.
Loudness 2 - Almost same as stock civic exhaust.
